Suitable to slow cars to approximately 10mph, it’s perfect for light car traffic use in car parks and private roads, including schools, hotels, hospitals, construction sites, factories and anywhere speeding could occur and cause accidents.

In highly visible yellow and black, the mid-sections feature cats eye night reflectors for increased visibility, day or night. Made from heavy-duty PVC with a chequered pattern to provide additional grip even in poor weather conditions, these are perfect for concrete and tarmac road surfaces with a load capacity of 20 tonnes.

Speed Bump 10mph – Kit Contents

Each kit contains an even number of yellow and black mid-sections, each measuring 500mm in length with four pre-drilled holes. You will also receive a yellow and a black end cap, measuring 170mm in length with two pre-drilled holes, allowing for an alternating yellow/black pattern from end-to-end. The speed ramp has a height of 50mm and a width of 350mm.

For example, the 1.35m kit has a yellow section, black section, yellow end, and black end. The 2.35m adds an extra yellow and black mid section, and the same for longer lengths.

The M10 shield anchor bolts are designed for heavy-duty, load-bearing applications. You’ll receive the exact amount you need to completely fasten the entire speed bump, 150mm in length. To install, first mark the position of bolts, drill the required holes and the correct size, insert the fixing and then secure the speed bump in place.

Where To Install Your Speed Bump

Speed bumps (sometimes also called sleeping policemen, speed humps and speed ramps) need to be installed straight across the road and away from junctions. Vehicles turning on a speed bump can make the driver and passenger uncomfortable and damage the bumps over time.

Usually installed in areas where vehicles and pedestrians mix, speed bumps work best when positioned at entrances or near zebra crossings and are an ideal speed deterrent for low-speed zones.